Apple1 ROMcard    Page No.:A16
			Just right from the beginning i knew that i would develop a ROMcard as alternate storage that will permit to load resident basic from Eprom instead  from loading it each time from tape. Eprom is more reliable than tape and faster too. And such an Epromcard would permit to create a kind of  "Utility Eprom" that contains an editor and a dissassembler as well as a assembler program or compiler or a diagnostic Eprom or just some  resident games.  This Card is designed for different kinds of usage: as ROM Card for 2708 or 2716 or 2732 Eproms - but also for use with 6116 Static RAM.  If the 6116 is used, the user may use a "backup-accumulator" on board as battery to keep the content of the static RAM nonviolatile for a  couple of days.  That feature is switched "on" or "off" by a slideswitch on top of the card.  This will enable the user to first use the Card with static RAM for development of the software, that is determined to be used in the Eprom.  Then - after that software has been tested - the card can be used with Eproms.  The design of the card contains microswitches and permits the adressrange of each socket to be chosen with four 4pol-DIL-microswitches  - so each Eprom may use its own selected adressrange.  Each socket permits to be free selectable with either 2708 / 2716/2732 or 6116 by a socket configuration plug.    I have also integrated the ability to program the Eproms with integrated ability to produce the needed programmingvoltage on the card.  The needed programmingvoltage can be switched "on" or "off" by Jumper at JP1 - and if it is switched on - it will be controlled by software  on the line"T" and the Read/Write-signal. The programmingvoltage of 12,5 Volt, 21 Volt, 25 Volt or 26 Volt will be selected by a jumper at JP2.    The +12 Volt and -12 Volt regulation is integrated too.
			new layout with far less hight and much better balance  by placing the the accumulator above the slot  former Layout ( too high )  with less good layout ( bad balance due to outside placement of accumulator )
			due to european laws and german court decision:  I hereby declare no responsibility to any "deep links" resulting from the links in this page. I have no influence to the pages linked hereby in this page and the  contents in those pages. I therefor can´t take any kind of responsibility to contents in the pages, where these links direct the readers browser to nor to the  contents resulting from following up links from those pages. The reference to contents by this links is dependent ro the status of the date when the links have  been set ( April 2013 ) and it might occur that references and contents may change by the fact that domains may have been discontinued from their former owners.  In such cases i can´t take any kind of responsibility to the changed contents. this is specialy valid to banners, advertisements or merchandising links in the targeted  pages.